Nexsan BEAST Series, User Manual, Page: 207 / 267

Reset to Factory Defaults
Clicking System Administration > Factory Settings takes you to the Reset to factory defaults page, where
you can reset various settings to their factory defaults.
Figure 3-150: Reset to factory defaults page
►
To reset system settings to factory defaults:
1. Select or deselect each check box as required:
Install factory default settings (except management network settings) : This will install factory
default values to the system. This may take up to 2 minutes to complete.
Additionally install default management network settings : This will install the default
management network settings. It requires Install factory default settings to be checked.
Redetect single/dual-controller mode : (E60P and E48P only) This will cause the device to redetect
the number of controllers and set the appropriate system mode.
Clear expansion chassis identities and settings : This will clear stored expansion chassis
identifiers (including friendly names and AutoMAID 5 settings).
Clear iSCSI host list : This will clear the stored iSCSI transport configurations for hosts.
Clear iSCSI and host access list : This will clear the stored iSCSI transport configurations and
access settings for hosts.
Clear all installed encryption keys (E-Series only): This will remove all encryption keys for
encrypted arrays. Ensure that you have downloaded and backed up all keys before selecting this
option (see
Configure Array Encryption on page 120).
Chapter 3: The Graphical User Interface — System Administration
Nexsan High-Density Storage
User Guide
www.nexsan.com
207