Nexsan BEAST Series, User Manual, Page: 167 / 267

On systems with four 10Ge iSCSI ports per controller, the Configure 10Ge iSCSI page looks like this:
Figure 3-120: Configure 10Ge iSCSI page (four ports per controller)
The information is arranged by Controller and then by host port. Current Status lists the link status (up or
down), link speed, and topology.
►
To change 10Gb Ethernet iSCSI port configuration:
1. In the Port Settings section, check the Jumbo Frames check box if you wish to enable jumbo frames
(9000 bytes, including all header information) for the 10Gb Ethernet port.
Note The port speed is fixed at 10Gbit Ethernet .
2. For Assign IP address , select either Use DHCP (Dynamic Host Configuration Protocol, the default) or
Use Static IP .
If you select Use DHCP , then no other configuration is needed.
Note In order to use DHCP, your network must be configured for DHCP. If it is not, you MUST use a
static IP address.
If you select Use Static IP , then you must enter the following:
Static IP address : Enter the fixed IP address you wish to use for the port.
Subnet mask : Enter the appropriate subnet mask for your network.
Gateway : Enter the IP address of the gateway used by your network.
Note If at any time you wish to return the Configure 10Ge iSCSI page to its initial state, click Reset .
Chapter 3: The Graphical User Interface — Configure Host Access
Nexsan High-Density Storage
User Guide
www.nexsan.com
167