Netscout OneTouch AT 10G, User Manual

Page: 229 / 248

Chapter 12: Link-Live Cloud Service
Setting Up and Accessing the Cloud Service
227
1
In Link-Live.com , navigate to the Units page from the left
sidebar.
2
Click the Claim Unit button at the lower right of the page.
3
Select your device (OneTouch), and follow the prompts on the
Link-Live website.
Once your OneTouch analyzer is successfully claimed, you should
see a successful claim message on Link-Live.com, and the claim
status on the unit should update to
Claimed .
Setting up Periodic AutoTest
When the analyzer is in Periodic AutoTest mode, the OneTouch
analyzer runs AutoTests at specified intervals and sends the results
to Link-Live so that you can view the results over time. Periodic
AutoTest is helpful when baselining network performance or
troubleshooting intermittent problems.
Periodic AutoTesting can be set up only after a unit has been
claimed. Your unit must be connected to a network for this
process to work. Your results can be sent through either of the
network test ports or the management port.
To enable Periodic AutoTest:
1
Select TOOLS from the HOME screen.
2
Under Link-Live Cloud Tools , select Periodic AutoTest
.
Note
A shortcut to the Periodic AutoTest screen is to touch
and hold the Test button on a unit’s HOME screen.
3
Configure the following:
Duration - The length of time during which test results will be
sent to the Link-Live Cloud. The duration can be set to Unlim-
ited Duration, 2, 5, 10, and 30 minutes, or 1 hour, 2 hours, 3
hours, 4 hours, 5 hours, 6 hrs, 8 hrs, and 12 hrs, or 1 day, 2 days,
3 days, 4 days, 5 days, or 1 week, or 2 weeks.
Interval - This is the amount of time between sent test results