Netscout OneTouch AT 10G, User Manual

Page: 124 / 248

OneTouch AT 10G
User Manual
122
Run the Test
To run the test, ensure that you have started the endpoint, then
start the 10G Wired Performance (Y.1564) test (on the source
OneTouch AT 10G) by tapping AutoTest or TEST AGAIN on the
test RESULTS tab.
How it Works
The 10G Performance (Y.1564) test works like this:
1
You configure the test either...

- by setting up specific test parameters on the
source
OneTouch AT 10G (a simple performance test), or...

- by selecting a test suite on the
peer
OptiView XG (typically, a
more complex test).
2
When the test is executed, usually as part of a OneTouch AT
10G test profile and an AutoTest run, the following
operations take place:

A test suite is created on the OptiView XG.

If a test suite from the OptiView XG is used:

The selected test suite’s configuration is copied to a
new test suite with “_OneTouch_AT_10G” appended
to its name.

You can select ANY test suite on the OptiView XG but
it must contain, at most, one active Endpoint and four
active Services.

The test suite you select is not altered.

If a “simple” performance test is used, the configuration
settings and the name entered on the OneTouch AT 10G
are transferred to the OptiView XG.

If the test suite above already exists on the OptiView
XG (from a previous run), its configuration and test
results (on the OptiView XG) are overwritten.

In all cases, the new test suite is populated with the
Endpoint address and port number of the
source
OneTouch AT 10G.