Netscout OneTouch AT 10G, User Manual

Page: 20 / 248

OneTouch AT 10G
User Manual
18
Charge the Battery
Before you use the battery for the first time, charge the battery
for about 2 hours with the analyzer turned off.
A fully-charged battery operates for approximately 4 hours of
typical use. The battery typically takes approximately 4 hours to
recharge from 10% to 90% when the analyzer is turned off.
Notes
You do not need to fully discharge the battery before
you recharge it.
The battery will not charge if its temperature is
outside the range of 32°F to 104°F (0°C to 40°C).
Switch the Power On
To turn on the analyzer, press the green power key

. The key
will illuminate and in a few seconds the HOME screen will appear.
Set the Language
1
On the HOME screen, tap the TOOLS icon (located in the
lower-left corner of the screen).
2
Scroll down to the Maintenance Tools section and tap
Language .
3
Select a language from the list.
4
Press the

key to return to the HOME screen.
Check the Battery Status
The battery status icon is located in the upper-left corner of
the screen. The battery status icon is normally green. It turns red
when the battery’s charge drops below 20%. If the battery is not
installed in the analyzer, the icon is red.
When the AC adapter is connected to the analyzer, the AC Power
Indicator LED (see Figure 4) is red while the battery is charging;
green when fully charged. If the battery’s temperature is too high