Netscout OneTouch AT 10G, User Manual

Page: 121 / 248

Chapter 5: User Tests
10G Wired Performance Test (Y.1564)
119
communicate with the OptiView XG. You set these values to
match what has already been configured on the OptiView XG.
This is used only when accounts and/or encryption are enabled on
the OptiView XG.
Use OptiView XG Test Suite - Turn this on when you want to use a
specific test suite that exists on the OptiView XG. Turn it off when
you want to set the configuration parameters on the OneTouch
to run a simple version of the 10G Wired Peformance (Y.1564)
test. See "How it Works" on
page 122 to learn more about test
suites.

Note:
When this parameter is turned on, only the Test Suite and
Port parameters below are available.
Test Suite - Specifies the name of the test suite on the OptiView
XG that will be used.

If the OneTouch AT 10G can connect to the OptiView XG,
when you tap this button, the list of Test Suites saved on
the OptiView XG will appear. You can then select a Test
Suite that has already been named on the OptiView XG.

If the OneTouch AT 10G cannot connect to the OptiView
XG, a keyboard will appear, allowing you to enter the
name of the of the Test Suite you plan to use.
Note:
The test suite must be configured appropriately to work as
a 10G Y.1564 Performance test. See "How it Works" on page 122
for more information.
Note
Except for Port, the configuration parameters shown
below are not visible when the
Use OptiView XG
Test Suite option is turned on.
Rate (bps) - Configures the desired bit rate of upstream
traffic (from the source analyzer to the peer). Valid rates are from
100 Kbps to 10 Gbps.
Rate (bps) - Configures the desired bit rate of downstream
traffic (from the peer to the source analyzer). Valid rates are from
100 Kbps to 10 Gbps.