Netopia 3300-ENT Series, Firmware User Manual

Page: 118 / 334

4-22 Firmware User Guide
Binding Map Lists and Server Lists
Once you have created your map lists and ser ver lists, for most Netopia Router models you must bind them to
a profile, either a Connection Profile or the Default Profile. You do this in one of the following screens:
• the IP profile parameters screen (see below) of the Connection Profile configuration menu
• the IP Parameters (WAN Default Profile) screen (see page 4-24 ) of the Default Profile configuration menu
• the Binding Map Lists and Ser ver Lists screen (see page 4-22 )
IP profile parameters
To bind a map list to a Connection Profile, from the Main Menu go to the WAN Configuration screen then the
Display/Change Connection Profile screen. From the pop-up menu list of your Connection Profiles, choose the
one you want to bind your map list to. Select
IP Profile Parameters and press Return.
The IP Profile Parameters screen appears.
• Select NAT Map List and press Return. A pop-up menu displays a list of your defined map lists.
Main
Menu
WAN
Configuration
IP Profile
Parameters
Display/Change
Connection Profile
IP Profile Parameters
Address Translation Enabled: Yes
IP Addressing... Numbered
NAT Map List... Easy-PAT List
NAT Server List... Easy-Servers
NAT Options...
Stateful Inspection Enabled: No
Local WAN IP Address: 0.0.0.0
Local WAN IP Mask: 0.0.0.0
Remote IP Address: 127.0.0.2
Remote IP Mask: 255.255.255.255
Filter Set...
Remove Filter Set
RIP Profile Options...
Toggle to Yes if this is a single IP address ISP account.
Configure IP requirements for a remote network connection here.