Netopia 3300-ENT Series, Firmware User Manual

Page: 248 / 334

8-16 Firmware User Guide
•
If you chose Automatic Recover y, select Requires Recovery of . Enter the number of minutes you want
the system to wait before attempting to switch back to the WAN connection. This allows you to be sure
that the WAN connection is well re-established before the gateway switches back to it from the backup
mode.
• Press Escape twice to return to the Main Menu.
IP Setup screen
To configure the backup gateway, from the Main Menu select System Configuration then IP Setup .
The IP Setup screen appears.
The IP Setup screen permits entr y of a backup IP gateway address. This field is always visible, even if the
Default IP Gateway field is not filled out, as in the case of a DHCP-acquired IP address and default gateway on
the WAN inter face.
For more information on IP Setup see the “IP Setup” on page 7-2 .
Note:
Backup and Recover y have resolutions of five seconds. This is how often the gateway evaluates the
state of the connections and makes decisions.
Main
Menu
System
Configuration
IP
Setup
IP Setup
Ethernet IP Address: 192.168.1.1
Ethernet Subnet Mask: 255.255.255.0
Define Additional Subnets...
Default IP Gateway: 0.0.0.0
Backup IP Gateway: 0.0.0.0
Primary Domain Name Server: 0.0.0.0
Secondary Domain Name Server: 0.0.0.0
Domain Name:
Receive RIP... Both
Transmit RIP... Off
Static Routes... IP Address Serving...
Network Address Translation (NAT)...
Enter an IP address in decimal and dot form (xxx.xxx.xxx.xxx).
Set up the basic IP attributes of your Netopia in this screen.