NEC NEAX 2000 IVS, Command Manual

Page: 72 / 473

ND-45669 (E) CHAPTER 2
Page 55
Revision 2.0
INFORMATION FOR DATA PROGRAMMING
4. PRECAUTION
4.1 Conditions for Using Commands
(1) Some commands require a system initialization (reset) after assignment/change of the office data, and oth-
ers cannot be assigned/changed unless the system is in off-line mode (a state in which call processing is
at a halt). These commands are shown in
Table 2-8 , categorized according to the conditions for their use.
Table 2-8 Commands and Their Using Conditions
CONDITION COMMAND REMARKS
Commands that require a reset of
MP card after data setting
• System reset is made by
pressing SW1 on MP card.
CM05: Card Assignment
CM06: MISC Trunk Number Assignment
CM07: DTI Trunk Assignment
CM08 – 390, 391: Basic Service Feature
CM09: Additional Service Features
CM10: Station Number/Trunk Number, and Card Number
(System initialization is required only for assigning the
PN-8RST, PN-CFT, ISDN Circuit).
CM1A: Data Station Number
CM60: YY = 00, 01, 02, 04, 06: ATTCON Tenant Group,
Functions
CM62: Tenants for each ATTCON Group
CMA9: ISDN-channel Assignment
CAF8: ID Code for Key FD
Commands that require a reset of
AP card (PN-AP00) after data set-
ting
• AP reset is made by moving
Make Busy switch UP and then
DOWN.
CMD001 – 20 – 35
– 80 – 156
Commands that can be used only
under Off-Line mode of MP card
(
see Section 4.2. )
CM00: System Data Memory All Clear
CM01: System Data Memory Partial Clear
CAT cannot use
these com-
mands.
Commands that can be used only
under Off-Line mode of AP card
(PN-AP00) (
See Section 4.2. )
CMD100: System Data Partial Clear
CMD101: System Data All Clear
CMD102: Expansion Memory Clear
INITIAL
AP INITIAL
System Features (2)
OFF LINE
AP OFF LINE