Nanosurf easyScan 2 AFM, Operating Instructions Manual

Page: 28 / 164

I
NSTALLING THE EASY
S
CAN
2 AFM
28
If you have already installed the control software for a Nanosurf Scanning
Probe Microscope on this computer, it is possible that nothing will happen,
because the drivers are installed already. If this is the case, click OK in the
Step 1 Dialog.
Once the computer has detected the new devices, it will display the ‘Found
New Hardware’ Dialog.
- Click on the text ‘Found New Hardware’ in the Windows task bar if the
‘Found New Hardware’ dialog is not displayed.
The ‘Found New Hardware ‘dialog, asks you when to install the drivers for
all the new devices that if found:
- Select the entry ‘Locate and install driver software (recommended)’.
The ‘Windows needs your permission to continue.’ Dialog is now dis-
played.
- Click the ‘Continue’-button
The following devices can be installed, depending on the configuration of
your controller:
• USB <-> serial interface
• USB Serial Port
• Unknown device (Video Module)
- Look up and carry out the installation instructions for each of these
devices given in the sections below.
If something went wrong during driver installation, continue the setup nor-
mally. When the setup is finished, refer to section
Driver problems (p.66).
- Click OK in the ‘Step 1’ dialog.
USB <-> serial interface
When the operating system finds the ‘USB <-> serial interface’, it asks what
to do:
- Click the ‘Next’ button or the default choice in all other dialogs.
The driver ‘USB High Speed Serial Converter’ is now installed.