Damper fixer
Tube fixer
Head cable
Head board assembly
R E P 1 4 3 0
Model Name: Rockhopper-46/62
R E P 1 4 3 0
Model Name: Rockhopper-46/62
How to replace the Dampers
How to replace the Dampers
Item
Replacement and Adjustment Procedure
1. Replacement
Procedure
2. Carry out a test print.
3. Fit a new Waste Fluid Bottle.
Dampers Replacement
1. Carry out Head Cleaning.
2. Remove the Panel Cover.
3. Remove the Front Cover.
4. Remove the Y Rail Cover.
5. Remove the Head Cover.
6. Cut the cable tie holding the head pipes.
7. Remove the damper fixer (2 fastening screws).
8. Remove joint screws and move the head pipes up out of the way.
9. Remove the colour dampers.
CAUTION:
When removing the colour dampers, be careful not
to grip the transparent film surface of the damper.
Rough handling of the transparent film surface
may cause an air leak and prevent printing.
10. Assembling is the reverse of the removal procedure.
1. Carry out initial filling.
CAUTION:
Wait at least 30 minutes after the initial filling
before printing. Otherwise the printing quality can
not be assured.
CAUTION:
About 150 cc of waste fluid will be expelled into
the Waste Fluid Bottle from head cleaning and initial
filling.
Fit a new Waste Fluid Bottle.
The message “Change Tank?” will appear on the
panel display. You should confirm by answering
“Yes”.
2. Adjustment and
Examination
Procedure
