MUTOH Falcon Outdoor 46, Maintenance Manual

Page: 298 / 333

B A C 4 0 0 0
Model Name: Rockhopper-46/62
B A C 4 0 0 0
Model Name: Rockhopper-46/62
Test Printing: Head Printing, Black in-filling, Parameters
Test Printing: Head Printing, Black in-filling, Parameters
This procedure is used for test printing. The items are as shown below. For adjust-
ment parameter prints, if no serial number has been entered, a serial number will
be requested. Online data signal reception is always enabled but no signals are
transmitted during the processing of a diagnostic sequence.
Procedures for the selection of items from panel are shown below.
Press [Back] to return to the Diagnostics Menu.
1. Head Printing Verification
To check that the head prints and print an adjustment pattern.
Item Details
Head Printing Verification Adjustment pattern printing
Check in-filling Black in-filling
Adjustment Parameters Display firmware adjustment parameters
Menu Up
Menu Up
Menu Down
Menu Down
PRINT: ChkNozzles End Print
ENTER
PRINT: Parameters
Menu Up Menu Down
PRINT: Black Fill
End
ENTER
DIAG: Test Print
Black infill printing
3. Adjustment Parameters
This procedure is used to print firmware adjustment parameters.
Press [ENTER] to print firmware adjustment parameters but if no serial number has
been registered, registration will be requested.
Adjustment Print
Panel
Adjustment Print
Panel
After the adjustment pattern printing has been finished, “PRINT: ChkNozzles” will
appear.
2. Check black in-filling
To print by filling an area with black colour.
Adjustment Print
Panel
After the adjustment pattern printing has finished, "Print: black in-fill" appears.