R E P 1 3 7 0 - 2
Model Name: Rockhopper 62
R E P 1 3 7 0 - 2
Model Name: Rockhopper 62
How to replace the Ink Tubes
How to replace the Ink Tubes
Item
Replacement and Adjustment Procedure
1. Replacement
Procedure
Replace the Ink Tubes
1.
Carry out Head Cleaning and empty the ink inside the tubes.
2.
Remove the Panel Cover.
3.
Remove the Front Cover.
4.
Remove the Y Rail Cover.
5.
Remove the head board assembly cable keeper and disconnect the
Y cable from the connector.
6.
Remove the ribbon cable guide and tube guide clamps.
7.
Undo the two screws holding the tube keeper.
8.
Remove the tube bracket cable keeper.
9.
Remove the four joining screws and O-rings on the Flexible Cable
Guide.
10. Remove the four joining screws and O-rings below the cursor.
11. Assembling is the reverse of the removal procedure.
→
Continued on next page
CAUTION:
Be careful not to lose the O-rings. Initial filling
and printing can not be done if the O-rings are
missing.
CAUTION:
Don’t use a tool to tighten the coupling screws
but get them as tight as possible with your fin-
gers. If you use a tool, there is a risk of breaking
the plastic taps.
« REFERENCE »
Ink tubes have a tendency to bend. Laying
the tubes in the direction of that tendency
prevents the tubes from behaving badly
and jamming.
« REFERENCE »
Couplings have a definite orientation. (See
diagram below)
Car
tr
idge side
Head side
Flexible cable guide
Joining screw
I
Ink tube
Ribbon cable guide
Clamping parts
Tube guide
Tube keeper
Cable keeper
Joining screw (large)
Joining screw (small)
