Innovation. Quality. Performance. Best in Industry. Worldwide.
Voltage Chart
Incoming at Switch
(L1,L2,L3)
____________
Transformed Power
(Pins 23&24)
____________
Mechanical Installation: PHASE II
Electricity is required.
Slightly loosen gantry bolts
– Loosen both sides of the X-axis (moving gantry only).
Hard Home
– If machine will not find limits, then see Help Docs.
Verify Resolutions
– See Help Docs for more information on how to check resolution
Verify Table Parameters
– Jog the full distance in X-, Y-, & Z-axes. Make sure that the gantry & head
do not make physical contact with the end stops.
Verify the cutting head is parallel to the table
.
Square Table
– Use a pen taped to the side of the head to make 4 points to verify the square of the
gantry. The bigger the perfect rectangle or square, the more accurate.
Tighten Gantry Bolts
– Tighten both sides of the X-axis (moving gantry only).
Suite4 Machine Software Installation
Reboot
Machine
– Check for red letter errors.
Capture
NVRAM
– Check the factory Flash settings before making any modifications. Save to
Computer and Tech computers.
Check Init and Firmware Version
– Type
v
& press
Enter
. Capture the screen or write down the
information. Make updates if necessary.
Interface Board
____________
Init File Version Loader
____________
Controller Board Revision
____________
Init File Version STD
____________
Firmware Version (MCIF)
____________ MD4
Version
____________
Help Files
– Manuals & Help Docs
JobNameServer
– Confirm operations.
JobReporter
– Confirm operations.
JobEditor
– Confirm operations.
ConnectionManager
– Confirm operations.
JobConsole
– Check if Auto Preview
works & if Job Monitor is on.
Routers * Lasers * Plasma * WaterJets * Knife Cutters
www.MultiCam.com
