Operators Guide
DigiBook 450
75
rel. 2.00-B
12
PREPARATION OF THE MACHINE TO PRODUCE A
BOOK.
12.1
CHECKS TO BE DONE BEFORE STARTING THE JOB
Before to use the binder perform the following controls:
The operator must have read and understood this manual, including the im-
portant information concerning the SAFETY.
Make sure you have appropriate clothing to work and, if necessary, also
safety clothing.
Ensure that the binder is properly powered and connected to ground (PE)
Ensure that the pneumatic system of the binder is properly fed and if the
main switch oh the factory is open.
Verify that the chips aspirator is connected to the binder and its power
switch is in position 1 = ON.
Check that in the tank there is a minimal amount of glue to allow to process
several books, otherwise insert a new cartridge of glue inside the tank.
Tank for glue collection flushed.
Ensure that the binder is clean and without books or covers, especially:
Clamp, Jogger, Milling Station, PUR head, Press.
Check that the settings for temperatures are correct for the used glue and that
have been achieved the correct values to work.
Refer to the technical sheets of the glue/cleaner manufacturer.
Verify that the values of temperatures have reached their work values.
Both temperature indicators must be lit.
If necessary, remove the layer of Blue-Cleaner from the PUR head.
5500 NE Moore Court
Hillsboro, OR 97124
Toll Free: 1-800-944-4573
Local: 503-640-5920
