Monarch NICE7000, User Manual

Page: 95 / 237

NICE7000 User Manual 5 System Commissioning and Functions
- 93 -
Function
Code
Parameter
Name
Setting Range
Setting in Parallel
Control
Setting in Group
Control
Fd-01 Elevator No. 1–8
1: master elevator
2: slave elevator
1: master elevator
2–8: slave elevator
Fd-02
Parallel/Group
control mode
0: Parallel control
Applicable to parallel
control of 2 elevators
2: Group control of
traditional mode Applicable to group
control
The parallel/group control function has the following features:
•
When hall calls are registered, the system calculates the response time of the elevators
in parallel/group control in real time (based on distance, elevator arrival, door open/
close), and responds to all calls in the optimum way, minimizing the passenger waiting
time.
• The elevators are configured as the master and slave ones. When they have the same
response conditions, the system instructs the master or slave to respond a call based
on the random function.
•
The parallel/group control function considers the call response time, elevator use
efficiency, and in-car passenger waiting time. It avoids use ratio imbalance of elevators,
implements coordination between elevators to respond to hall calls and improves the
elevator use efficiency.
The following part describes the parallel control and group control in detail.
1) Parallel control
•
Parameter setting
To use parallel control, connect the CAN2+ and CAN2- terminals of CN6 on the
controller to respectively the corresponding terminals on the other one.
The following table lists the parameter setting of parallel control.
Table 5-6 Parameter setting of parallel control
Function Code Parameter Name Setting Range Setting in Parallel Control
Fd-00
Number of elevators in
parallel/group mode
1–2 1–2
Fd-01 Elevator No. 1–2
1: master elevator
2: slave elevator
•
Address Setting of Physical Floors
Physical floor, relative to the NICE control system, is defined by the installation position
of the leveling plate.
The floor (such as the ground floor) at which the lowest leveling plate is installed
corresponds to physical floor 1.
The top physical floor is the accumulative number of the leveling plates.