Route and Connect Servo Cables - continued
4. Once cables have been routed, use cable ties to hold cables in place.
See below for correct connector alignment.
Figure 7-2 Cables held with wire ties
Align arrows on connector halves
Figure 7-3 Correct connector alignment
7.1.2 Route and Connect Heater, I/O, Injection Molding
Machine Cables
1. Uncoil the heater and I/O cables and make sure they are not damaged or
twisted.
2.
Connect the “MOLD END” of the heater cable to the connector on the
E-Multi injection unit.
3.
Connect the “MOLD END” of the I/O cable to the connector on the E-Multi
injection unit.
4. Route the cables towards the motor end of the E-Multi injection unit,
taking care not to interfere with any moving parts or obstructing the air
connection. The cables may be tied to the motor end shipping bracket, if
required.
5.
Connect the “CONTROLLER END” of the cables to the “BARREL HEAT
CONNECTOR” and “AUX INJ. UNIT” connectors on the controller. See
7-2
E-Multi User Manual
SYSTEM SETUP
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
