Table 3-7 Safety Symbols Used on the E-Multi
Symbol
General Description
General – Warning
Indicates an immediate or potentially hazardous situation, which if not
avoided, could result in a serious injury or death, and/or damage to
equipment
Warning – Body Crush Hazard
End of motor moves back during hold or recovery. Hazard may exist
between the end of the injection unit motor assembly and a nearby solid
obstacle.
Warning – Tip Over Hazard
Injection unit could tip over when installed on stand or if stored vertically on
the floor or a table without adequate support.
Warning – Electric Shock Hazard
Contact with hazardous voltages will cause death or serious injury. Turn off
power and review electrical schematics before servicing equipment. May
contain more than one live circuit. Test all circuits before handling to make
sure circuits have been de-energized.
Warning – Hot Surface Hazard
Contact with exposed hot surfaces will cause serious burn injury. Wear
adequate personal protective equipment (PPE) when working near these
areas.
Warning – Entanglement Hazard (Belt Drive)
A person could become entangled in the drive belt of the injection unit.
Always keep guards in place.
Warning - Pinch Point Hazard
A pinch point exists in this area which could result in a pinching, crushing or
shearing injury to a person.
Warning – Splashing Hazard
Molten material or high pressure gas can cause death or severe burns.
Wear personal protective equipment (PPE) while servicing the feed throat,
nozzle, mold areas, and when purging the injection unit.
Mandatory – Read Service Manual Before Operation
Personnel should read and understand all instructions in the manuals
before working on equipment. Only properly trained personnel should
operate the equipment.
Mandatory Lift Points
Mandatory lift points must be used. If wrong lift points are used the unit
could become unstable when being moved.
3.11 Safety Symbols on the E-Multi Injection Unit
3-18
E-Multi User Manual
SAFETY
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
