Section 11 - E-Multi Radial
Option
WARNING
Ensure you have fully read “Section 3 - Safety” before unpacking,
assembling or installing the E-Multi Radial Option.
11.1 Introduction
This section provides information that is special to the E-Multi Radial
machine-mounted solution for E-Multi injection units.
The E-Multi Radial is designed to be mounted to the top of the stationary
platen of an injection molding machine, where it can conveniently swing out
of the way of the mold mounting face. This speeds up mold changes, as
there is no need to remove the E-Multi injection unit when changing a mold.
An additional benefit is that the full weight of the E-Multi injection unit is
supported by the injection molding machine, rather than the mold.
The E-Multi Radial has a servo controlled carriage axis which allows the
system to be operated in sprue-break mode or in continuous nozzle contact
mode.
In sprue break mode, the nozzle retracts and extends with each injection
cycle, as required for parting line injection application.
11.2
E-Multi Radial Specifications
Table 11-1
E-Multi Radial Specifications
E-Multi
Model
Typical
Clamp Size
Vertical
(Carriage)
Stroke
(z-axis)
Mold Face
Reach
(x-axis)
Rotation
(Injection
Molding
Machine
Center)
Nozzle
Contact
Force
Sprue
Break
(Carriage
Stroke)
Sprue
Break
(Average
Velocity)
ER1-15
ER1-30
100 - 450
ton
90 - 400
tonne
0 - 415 mm 50 - 350 mm
-120° CCW
+120° CW
10 kN
≤ 50 mm
50 mm/sec
ER2-50
ER2-80
17 kN
ER3-100
ER3-200
300-2000
ton
275 - 1800
tonnes
0 - 825 mm
60 - 500 mm
40 kN
ER4-350
ER4-550
400 - 4000
ton
365 - 3600
tonnes
70 - 500 mm
11-1
E-MULTI RADIAL OPTION
E-Multi User Manual
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
