3.7 Disposal
WARNING
Milacron
Mold-Masters
declines any responsibility for personal injury or
personal damage arising from reuse of the individual components, if these
parts are used other than for the original and proper intended purpose.
Recycling of the materials occupies a forefront position during the disposal
process.
1. Hot runner and system components must be disconnected from the
power supply fully and properly before disposal, including electricity,
hydraulics, pneumatics and cooling.
2.
Ensure that the system to be disposed of is free from fluids. In the
case of hydraulic needle valve systems, drain the oil from the lines and
cylinders and dispose it in an environmentally responsible manner.
3. The electrical components are to be dismantled, separating them
accordingly as environmentally friendly waste or disposed as hazardous
waste if necessary.
4. Remove the wiring. The electronic components are to be disposed in
accordance with the national electric scrap ordinance.
5. The metal parts are to be returned for metal recycling (waste metal
and scrap trade). The instructions of the corresponding waste disposal
company are to be observed in this case.
Recycling of the materials occupies a forefront position during the disposal
process.
3-12
E-Multi User Manual
SAFETY
© 2020 Mold-Masters (2007) Limited. All Rights Reserved.
