Mitsubishi MOTORS OUTLANDER, Owner'S Manual

Page: 468 / 602

Fluid type
Use brake fluid conforming to DOT3 or
DOT4 from a sealed container. The brake flu-
id is hygroscopic. Too much moisture in the
brake fluid will adversely affect the brake
system, reducing the performance.
WARNING
l
Take care in handling brake fluid as it is
harmful to the eyes, may irritate your
skin and will damage painted surfaces.
Wipe up any spills immediately.
If brake fluid gets on your hands or in
your eyes, flush immediately with clean
water. Follow up with a doctor as necessa-
ry.
CAUTION
l
Use only the specified brake fluid.
Do not mix or add different brands of brake
fluid to prevent chemical reaction.
Do not let any petroleum-based fluid touch,
mix with, or get into the brake fluid.
This will damage the seals.
l
Keep the reservoir tank cap closed to pre-
vent the brake fluid from deteriorating ex-
cept maintenance.
l
Clean the filler cap before removing and
close the cap securely after maintenance.
Battery
E01001203545
The condition of the battery is very important
for quick starting and to keep the vehicle’s
electrical system working properly. Regular
inspection and care are especially important
in cold weather.
NOTE
l
After replacing the battery, the electronic
control system data for the automatic trans-
mission, etc., will be erased. As a result,
shift shocks may occur.
Shift shocks will become smoother after sev-
eral changes in speed.
Checking battery electrolyte
level
The electrolyte level must be between the
specified limit on the outside of the battery.
Replenish with distilled water as necessary.
The inside of the battery is divided into sev-
eral compartments; remove the cap from each
compartment and fill to the upper mark. Do
not top up beyond the upper mark because
spillage during driving could cause damage.
Check the electrolyte level at least once every
4 weeks, depending on the operating condi-
tions.
If the battery is not used, it will discharge by
itself with time.
Check it once every 4 weeks and charge with
low current as necessary.
Removing and installing the air
duct (Except for 3000 models)
To replenish with the distilled water, remove
the air duct.
WARNING
l
Turn the ignition switch to the “LOCK”
position or put the operation mode in
OFF.
Make sure that your clothes cannot be
caught by the fan or drive belt. Personal
injury could result.
Battery
10-09
OGFE19E1
Maintenance
10