Mitsubishi MOTORS OUTLANDER, Owner'S Manual

Page: 286 / 602

NOTE
l
A sound will be heard during the activation
of automatic braking, this is a function of the
brake control and is not abnormal.
FCM and UMS ON/OFF
switch
E00635601310
This switch is used to turn on and off the
FCM and UMS and also to select your de-
sired collision alarm timing.
When the switch is held pressed, the
ON/OFF state of the FCM and UMS changes
from ON to OFF and vice versa. If you give
the switch a short press with the FCM in the
ON state, you can change the collision alarm
timing.
NOTE
l
When the FCM and UMS ON/OFF switch is
held pressed to change the ON/OFF state of
the FCM, the ON/OFF state of the UMS is
also changed at the same time.
To turn on/off the system
You can switch the system from OFF to ON
or ON to OFF if you hold the FCM and UMS
ON/OFF switch pressed when the operation
mode is set to “ON”.
Once the system is turned on, the information
screen of the multi information display shows
the collision alarm timing currently selected,
and the indicator on the screen goes out.
When you turn off the system, the following
message appears on the screen and the in-
dicator comes on.
Cycling the operation mode to ON will set
the FCM back ON.
NOTE
l The indicator is combined with the
“UMS OFF” indicator.
To change alarm timing
Give a short press to the FCM and UMS
ON/OFF switch to change the timing at
which the frontal collision alarm is triggered.
Every time you press the switch, the alarm
timing changes between three levels: “FAR”
(earlier alarming), “MIDDLE” (normally
alarming) or “NEAR” (later alarming).
As you make selection, the selected alarm
timing is displayed on the information screen
of the multi information display. Even after
turning off the FCM or setting the operation
mode to “OFF”, the system retains your last
selected alarm timing in memory.
Forward Collision Mitigation System (FCM)*
6-97
OGFE19E1
Starting and driving
6