Mitsubishi MOTORS OUTLANDER, Owner'S Manual

Page: 34 / 602

To lock
Press the LOCK switch (1). All the doors and
the tailgate will be locked. The turn-signal
lamps will blink once when the doors and the
tailgate are locked.
To unlock
Press the UNLOCK switch (2). All the doors
and the tailgate will be unlocked. If the doors
and tailgate are unlocked when the front
room lamp switch is in the “DOOR” position
or the rear room lamp switch is in the middle
(•) position, the room lamp will illuminate for
approximately 15 seconds and the turn-signal
lamps will blink twice.
The position and tail lamps can also be set to
turn on for approximately 30 seconds. Refer
to “Instruments and controls: Welcome light”
on page 5-64.
NOTE
l
Except for vehicles equipped with a Dead
Lock System, the door and tailgate unlock
function can be set so that only the driver’s
door unlocks when the UNLOCK switch (2)
is pressed once.
If the door and tailgate unlock function is set
to work as described above, all the doors and
the tailgate unlock when the UNLOCK
switch is pressed two times in succession.
Refer to “Setting of door and tailgate unlock
function” on page 3-06.
l
On vehicles with keyless entry system and
equipped with the mirror retractor switch,
the outside rear-view mirrors automatically
retract or extend when all the doors and tail-
gate are locked or unlocked using the remote
control switches of the keyless entry system.
Refer to “Starting and driving: Outside rear-
view mirrors” on page 6-12.
l
If the UNLOCK switch (2) is pressed and no
door or tailgate is opened within approxi-
mately 30 seconds, relocking will automati-
cally occur.
l
It is possible to modify functions as follows:
For further information, please contact your
MITSUBISHI MOTORS Authorized Serv-
ice Point.
On vehicles equipped with the Smartphone
Link Display Audio or the MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make the
adjustment. Refer to the separate owner’s
manual for details.
NOTE
• The time for automatic relocking can be
changed.
• The confirmation function (flashing of the
turn-signal lamps) can be set to operate
only when the doors and backdoor are
locked or only when the doors and back-
door are unlocked.
•
The confirmation function (this indicates
locking or unlocking of the doors and tail-
gate with the flash of the turn-signal
lamps) can be deactivated.
•
The number of times the turn-signal
lamps are flashed by the confirmation
function can be changed.
l
The keyless entry system does not operate in
the following conditions:
• The key is left in the ignition switch. (ve-
hicles with keyless entry system)
• The operation mode is not in OFF. (vehi-
cles with keyless operation system)
• The door or tailgate is open.
l
The remote control switch will operate with-
in approximately 4 m from the vehicle.
However, the operating range of the remote
control switch may change if the vehicle is
located near a power station, or radio/TV
broadcasting station.
l
If either of the following problems occurs,
the battery may be exhausted.
• The remote control switch is operated at
the correct distance from the vehicle, but
the doors and tailgate are not locked/
unlocked in response.
Keyless entry system
3-05
OGFE19E1
Locking and unlocking
3