Mitsubishi MOTORS OUTLANDER, Owner'S Manual

Page: 275 / 602

NOTE
l
Even if the ACC is in the activated state
when the ignition switch or operation mode
is set to “OFF”, the system does not auto-
matically become activated when the igni-
tion switch or operation mode is set to “ON”
next time.
To activate ACC control
With the ACC turned on (in the ‘standby
state’), push down the “SET -” switch while
driving.
When your desired speed is reached, release
the “SET -” switch; then this speed is set and
the ACC initiates the speed control to the set
speed.
The set speed is indicated on the information
screen of the multi-information display.
The ACC can be selected between approxi-
mately 40 km/h (25 mph) to 180 km/h
(112 mph).
You can set and initiate the speed control
when driving at approximately 10-40 km/h
(6-25 mph) while a vehicle in front is being
detected. In this case, the target speed is set
to 40 km/h (25 mph). Setting to any speed
outside this range does not cause the ACC to
start the control.
When the ACC is initialized, a buzzer sound
is heard and the “SET” indicator lights up on
the screen. At the same time, the display
showing the following distance setting and
the running-ahead vehicle symbol (only when
the ACC is detecting a vehicle in front) is
switched to the in-control mode display.
NOTE
l
The ACC cannot start the control when any
of the following conditions is present. You
are alerted to this state by a sounding buzzer.
• When the vehicle speed is lower than ap-
proximately 10 km/h (6 mph) or 180 km/h
(112 mph) or higher.
•
When the vehicle is running at a speed be-
tween approximately 10 and 40 km/h and
the ACC is not detecting any vehicle in
front.
•
When the ASC is in the OFF state.
• When ABS, ASC or TCL is working.
Adaptive Cruise Control System (ACC)*
6-86
OGFE19E1
Starting and driving
6