Mitsubishi MOTORS OUTLANDER, Owner'S Manual

Page: 231 / 602

4. Insert a straight blade (or minus) screw-
driver in the shiftlock release hole (A).
Shift the selector lever to the “N” (NEU-
TRAL) position while pressing the
straight blade (or minus) screwdriver
down.
Selector lever position display
E00602300424
When the ignition switch is turned to the
“ON” position or the operation mode put in
ON, the position of the selector lever is indi-
cated in the multi information display.
Type 1 Type 2
When the selector lever position
display blinks
E00637700044
WARNING
l
To avoid unintended vehicle movement,
keep the brake pedal applied with your
right foot and do not depress the accelera-
tor pedal, while the selector lever position
display is blinking.
If the ambient temperature is low, the selector
lever position display on the multi informa-
tion display may blink when the selector lev-
er is placed in the “D” (DRIVE), “Ds”
(DOWNSHIFT & SPORTY DRIVING), “L”
(LOW) or “R” (REVERSE) position immedi-
ately after the engine has been started. This
indicates that the transmission requires
warming up.
While the display is blinking, the vehicle will
not move, because the transmission keeps
disengaging until the warm up is completed
even if the selector lever is placed in the “D”,
“Ds”, “L” or “R” position.
When the selector lever position display is
blinking, perform the following procedure:
1. Depress the brake pedal with your right
foot and place the selector lever in the
“N” (NEUTRAL) position for several
seconds.
2. Keep depressing the brake pedal and
then place the selector lever in the “D”
(DRIVE), “Ds” (DOWNSHIFT &
SPORTY DRIVING), “L” (LOW) or
“R” (REVERSE) position. If the selector
lever position display stops blinking, the
warm-up is completed and the transmis-
sion will function normally.
3. If the display is still blinking, repeat
steps 1 and 2 above.
Automatic transmission INVECS-III 6CVT (Intelligent & Innovative Vehicle Electronic Control System III)*
6-42
OGFE19E1
Starting and driving
6