Mitsubishi MOTORS Outlander 2007, Owner'S Manual

Page: 50 / 618

1-28
Locking and unlocking
1
NOTE
●
If the engine is cold, the diesel preheat indicator lamp will
stay on for a longer time.
●
When the engine has not been started within about 5 sec-
onds after the diesel preheat indicator lamp went out,
return the ignition switch to the “LOCK” position. Then
turn the switch to the “ON” position to preheat the engine
again.
●
When the engine is warm, the diesel preheat indicator
lamp will not come on when the ignition switch is turned
to the “ON” position.
Start the engine by turning the ignition switch directly to
the “START” position.
6. Turn the ignition switch to the “START” position without
depressing the accelerator pedal and release it when the
engine starts.
NOTE
●
A ticking noise may be heard after the engine has started.
This is not an abnormal condition. The noise will disap-
pear after the engine has run for a short time.
If the ticking noise continues after the engine is warmed
up, please contact your MITSUBISHI MOTORS Author-
ised Service Point.
To operate without using the keyless operation
function
E00306000019
Emergency key
E00307200092
The emergency key is integrated into the KOS key (keyless
operation key). If the keyless operation function is not working
e.g. because of a discharged KOS key battery or vehicle bat-
tery, you can lock and unlock the doors and start the engine
with the emergency key. To use the emergency key (A), slide
the lock knob (B) into the release position and remove the
emergency key from the KOS key (C).