Mitsubishi MOTORS Outlander 2007, Owner'S Manual

Page: 319 / 618

Starting and driving
4-77
4
Reversing sensor system detection areas
Depending on whether the vehicle is equipped with a towbar,
you can change the reversing sensor system between the stand-
ard mode and the towbar mode. The towbar mode changes the
system to exclude the area in which the towbar is mounted
from the detection areas.
Vehicles without a towbar
The detection areas are within approximately 60 cm (A) from
the corner sensors, 150 cm (B) from the back sensors, and 60
cm (C) or less from the ground surface, excluding the area
approximately 10 cm (D) from the ground surface.
Vehicles with a towbar
The detection areas are within approximately 60 cm (A) from
the corner sensors, 150 cm (B) from the back sensors, and 60
cm (C) or less from the ground surface, excluding the area
approximately 10 cm (D) from the ground surface. The nonde-
tection areas (E) are within approximately 20 cm (F) from the
bumper.
NOTE
●
If the rear bumper has been exposed to an impact, the cor-
ner or back sensors may fail and prevent the system from
functioning properly. Have the vehicle inspected at a
MITSUBISHI MOTORS Authorised Service Point.
●
The sensors do not detect objects located in the area
directly below or near the bumper. If the height of an
object is lower than the mounted position of the corner or
back sensors, the sensors may not continue detecting it
even if they detected it initially.