Mitsubishi MOTORS Lancer 2017, Owner'S Manual

Page: 75 / 385

Keyless entry system (if so equipped)
5-10 Features and controls
5
1. Have available all (current and new)
remote control transmitters you wish to
register.
2. With a valid (already registered) remote
control transmitter, press the UNLOCK
button (2) for 4 to 10 seconds. Then press
and hold the LOCK button (1).
3. Within 10 seconds of pressing the LOCK
button, release the LOCK and UNLOCK
buttons in sequence.
At this time, ID codes for all remote con-
trol transmitters except for the transmitter
used in steps 2 and 3 are erased and the
answerback function (door is locked and
unlocked) informs you that the registra-
tion mode has been activated.
4. Within 60 seconds after step 3, complete
the following ID code registration opera-
tion using the next remote control trans-
mitter you wish to register within
4 seconds.
i. Press both the LOCK and UNLOCK
buttons for 2 seconds.
ii. Release both the LOCK and UNLOCK
buttons for 1 second.
iii. Press the UNLOCK button.
The answerback function informs you
that the ID code registration of the
transmitter is completed.
5. To register the ID codes of additional
remote control transmitters, repeat step 4
within 60 seconds after step 4.
6. If no ID code of a remote control trans-
mitter is registered within 60 seconds
after step 4, the registration mode is can-
celed and the normal mode returns.
N00546101111
Your keyless entry system operates on a radio
frequency subject to Federal Communica-
tions Commission (FCC) Rules (For vehicles
sold in U.S.A.) and Industry Canada Rules
(For vehicles sold in Canada). This device
complies with Part 15 of FCC Rules and
Industry Canada licence-exempt RSS stan-
dard(s).
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
NOTE
 For verification purposes, try to lock and
unlock the doors after the registration is
completed.
 The indicator light (5) comes on each time a
button is pressed.

The keyless entry system does not work if
the key is in the ignition switch.
 The remote control transmitter can be used
from about 40 feet (12 m) away. However,
this distance may change if your vehicle is
near a TV transmitting tower, a power sta-
tion, or a radio station.
 If the UNLOCK button (2) is pressed when
all doors are locked and no doors are opened
within about 30 seconds, the doors will auto-
matically re-lock.
 If the following conditions are observed after
pressing the buttons on the remote control
transmitter, the battery in the remote control
transmitter may need to be replaced.
• The doors cannot be locked or unlocked.
• The trunk lid cannot be opened.
• The panic alarm cannot be operated.
• The indicator light (5) is dim or does not
come on.
 If you lose your remote control transmitter,
please contact an authorized Mitsubishi
Motors dealer for a replacement.
 If you wish to obtain an additional remote
control transmitter, please contact an autho-
rized Mitsubishi Motors dealer. A maximum
of eight remote control transmitters can be
programmed for your vehicle.
 To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to “Electronic immobilizer (Anti-
theft starting system): Customer key pro-
gramming” on page 5-6.
General information
NOTE
BK0237700US.book 10 ページ ２０１６年４月１５日 金曜日 午前１１時２８分