Mitsubishi MOTORS Lancer 2017, Owner'S Manual

Page: 152 / 385

Tire pressure monitoring system
Features and controls 5-87
5
The tire pressure monitoring system may not
work normally in the following circum-
stances:
 A wireless facility or device using the
same frequency is near the vehicle.
 Snow or ice is stuck inside the fenders
and/or on the wheels.
 The tire inflation pressure sensor’s battery
is dead.
 Wheels other than Mitsubishi genuine
wheels are being used.
 Wheels that are not fitted with tire infla-
tion pressure sensors are being used.
 Wheels whose ID codes are not memo-
rized by the vehicle are used.
 Compact spare tire is fitted on a road
wheel.
 A window tint that affects the radio wave
signals is installed.
N00532900179
If new wheels with new tire inflation pressure
sensors are installed, their ID codes must be
programmed into the tire pressure monitoring
system. Have tire and wheel replacement per-
formed by an authorized Mitsubishi Motors
dealer to avoid the risk of damaging the tire
inflation pressure sensors. If the wheel
replacement is not done by an authorized
Mitsubishi Motors dealer, it is not covered by
your warranty.
N00533001259
Your tire pressure monitoring system oper-
ates on a radio frequency subject to Federal
Communications Commission (FCC) Rules
(For vehicles sold in U.S.A.) and Industry
Canada Rules (For vehicles sold in Canada).
This device complies with Part 15 of FCC
Rules and Industry Canada licence-exempt
RSS standard(s).
Operation is subject to the following two con-
ditions.
 This device may not cause harmful inter-
ference.
 This device must accept any interference
received, including interference that may
cause undesired operation.
CAUTION
 If a tire has a puncture, replace that tire with
the spare tire. Driving on a punctured tire
could lead to an accident.
 The warning light/display may not illuminate
immediately in the event of a tire blowout or
rapid leak.
NOTE
 To avoid the risk of damage to the tire infla-
tion pressure sensors, have any punctured
tire repaired by an authorized Mitsubishi
Motors dealer. If the tire repair is not done by
an authorized Mitsubishi Motors dealer, it is
not covered by your warranty.
 Do not use an aerosol puncture-repair prod-
uct on any tire. Such a spray could damage
the tire inflation pressure sensors. Have any
puncture repaired by an authorized Mitsubi-
shi Motors dealer.
NOTE
 Tire inflation pressures vary with the ambi-
ent temperature. If the vehicle is subjected to
large variations in ambient temperature, the
tire inflation pressures may be under-inflated
(causing the warning light/display to come
on) when the ambient temperature is rela-
tively low. If the warning light/display
comes on, adjust the tire inflation pressure.
Whenever the tires and wheels
are replaced with new ones
CAUTION
 The use of non-genuine wheels will prevent
the proper fit of the tire inflation pressure
sensors, resulting in air leakage or damage to
the sensors.
General information
BK0237700US.book 87 ページ ２０１６年４月１５日 金曜日 午前１１時２８分