Mitsubishi MOTORS Lancer 2017, Owner'S Manual

Page: 164 / 385

Multi-information display
Features and controls 5-99
5
Shows the distance and number of months
until the next periodic inspection.
Refer to “Service reminder” on page 5-103.
Shows the engine coolant temperature.
If the coolant becomes hot, “ ” will blink.
Pay careful attention to the engine coolant
temperature display while you are driving.
Shows the approximate driving range (how
many more miles or kilometers you can
drive) with the current fuel level. When this
driving range falls below 30 miles (50 km), “-
--” is displayed.
Refuel as soon as possible.
This displays the average speed from the last
reset to the present.
There are 2 types of mode settings as follows.
For details on how to change the average
speed display setting, refer to “Changing the
function settings (With ignition switch in the
“ON” position)” on page 5-105.
 When the average speed is being dis-
played, if you hold down the multi-infor-
mation meter switch, the average speed
displayed at that time is reset.
 When the ignition switch is turned to the
“ON” position from the “ACC” or
“LOCK” position, the mode setting
changes automatically from manual to
auto.
Switching to auto occurs automatically. If
switching to manual mode is done, how-
ever, the data from the last reset is dis-
played.
 When the average speed is being dis-
played, if you hold down the multi-infor-
mation meter switch, these calculations
will be reset to zero.
 When the ignition switch has been set to
the “ACC” or “LOCK” position for about
4 hours or more, the average speed dis-
play will automatically reset.
Service reminder
Engine coolant temperature dis-
play
CAUTION
 If the engine is overheating, “ ” will blink.
In this case, the bar graph is on the red zone.
Immediately park the vehicle in a safe place
and take the required measures. Refer to
“Engine overheating” on page 8-4.
Driving range display
NOTE
 The driving range is determined based on the
fuel consumption data. This may vary
depending on the driving conditions and hab-
its. Treat the distance displayed as just a
rough guideline.
 When you refuel, the driving range display is
automatically updated.
However, if you only add a small amount of
fuel, the correct value will not be displayed.
Fill to a full tank whenever possible.
 When your vehicle is stopped on an
extremely steep hill, the driving range value
may change. This is due to the movement of
fuel in the tank and does not indicate any
problem.
 The display setting can be changed to the
preferred units (miles or km).
Refer to “Changing the function settings
(With ignition switch in the “ON” position)”
on page 5-105.
Average speed display
Manual reset mode
Auto reset mode
NOTE
 The average speed display and the average
fuel consumption display can be reset sepa-
rately in both auto reset mode and manual
reset mode.
BK0237700US.book 99 ページ ２０１６年４月１５日 金曜日 午前１１時２８分