Mitsubishi MOTORS Lancer 2017, Owner'S Manual

Page: 71 / 385

Electronic immobilizer (Anti-theft starting system)
5-6 Features and controls
5
For you to register the ID code yourself, fol-
low the “Customer key programming” proce-
dure below.
If you choose to have your authorized Mit-
subishi Motors dealer register the ID code,
take your vehicle and all remaining keys to
your authorized Mitsubishi Motors dealer.
N00562201152
You can program new keys to the system if
you have two valid (already registered) keys
and blank (not registered) immobilizer key
(specially cut for your vehicle at your Mit-
subishi Motors dealer) by doing the follow-
ing:
1. Insert the first valid key into the ignition
switch and turn the key to the “ON” posi-
tion for 5 seconds.
2. Turn the key to the “LOCK” position and
remove the first key.
3. Within 30 seconds of turning the first key
to the “LOCK” position, insert the second
valid key into the ignition and turn it to
the “ON” position. About 10 seconds
later, the immobilizer display will start to
blink.
4. When the immobilizer display starts
blinking, turn the second valid key to the
“LOCK” position and remove it. Within
30 seconds after doing so, insert a blank
immobilizer key into the ignition switch
and turn it to the “ON” position. Perform
this operation no more than 30 seconds
after the immobilizer display starts blink-
ing. When registration of the ID code is
complete, the immobilizer display will
come on for 30 seconds then go off. If an
error occurs, the immobilizer display will
go off during the procedure.
5. If you wish to register another key, per-
form the process again from step 1.
Your electronic immobilizer operates on a
radio frequency subject to Federal Communi-
cations Commission (FCC) Rules (For vehi-
NOTE
 You are provided with two keys, but you
may register up to eight keys.
Customer key programming
(Except for vehicles sold in
Canada)
NOTE
 Perform the operation when the interrupt dis-
play screen is not showing. The interrupt dis-
play screen may prevent you from seeing the
immobilizer display.
 It is not possible to register a key if:
• the immobilizer display goes off during the
procedure
• the immobilizer display does not come on
within 30 seconds after turning the ignition
switch to the “ON” position with a blank
immobilizer key
 The procedure will be terminated automati-
cally if:
• a period of 30 seconds or longer elapses
from the moment when the first key is
turned to the “LOCK” position to the
moment when the second key is turned to
the “ON” position
• a period of 30 seconds or longer elapses
from the moment when the second key is
turned to the “LOCK” position to the
moment when the blank immobilizer key is
turned to the “ON” position
 To use the new remote control transmitters, it
is necessary to register the key with both the
electronic immobilizer and keyless entry sys-
tem.
Also refer to “Keyless entry system: Cus-
tomer remote control transmitter program-
ming” on page 5-9.
General information
NOTE
BK0237700US.book 6 ページ ２０１６年４月１５日 金曜日 午前１１時２８分