Mitsubishi MOTORS Lancer 2017, Owner'S Manual

Page: 309 / 385

How to change a tire
8-6 For emergencies
8
Turn the shaft end (1) so that the jack con-
tracts, then remove it from the storage bracket
(C).
Turn the shaft end (2) by hand to expand the
jack until it is held firmly in position.
N00836901858
Before changing a tire, first stop your vehicle
in a safe, flat location.
1. Park the vehicle on level and stable
ground.
2. Set the parking brake firmly.
3. On vehicles with manual transaxle, turn
the ignition switch to the “LOCK” posi-
tion, and move the gearshift lever to the
“R” (Reverse) position.
On vehicles with continuously variable
transmission (CVT), move the selector
lever to the “P” (PARK) position, and turn
the ignition switch to the “LOCK” posi-
tion.
4. Turn on the hazard flashers and set up a
warning triangle, flashing signal light,
etc., at an adequate distance from the
vehicle, and have all your passengers
leave the vehicle.
5. To prevent the vehicle from rolling when
it is raised on the jack, place chocks or
blocks (A) at the tire that is diagonally
opposite from the tire (B) you are chang-
ing.
To remove
To store
How to change a tire
WARNING
 The jack should not be used for any pur-
pose other than to change a tire.
 Never get under the vehicle or put any
portion of your body under the vehicle
while it is supported by the jack.
WARNING
 Be sure to apply chocks or blocks to the
correct tire when jacking up the vehicle. If
the vehicle moves while jacked up, the
jack could slip out of position, leading to
an accident.
BK0237700US.book 6 ページ ２０１６年４月１５日 金曜日 午前１１時２８分