Mirapoint RazorSafe 700, Hardware Manual

Page: 27 / 98

LCD Status Messages
21
E2010 Memory not detected.
Inspect DIMMs. No memory was detected
in the appliance. Install memory or
reseat the memory
modules. See
Installing
Memory Modules on
page 56 or
Troubleshooting
Memory
on page 76.
E2011 Memory configuration
failure. Check DIMMs. Memory detected, but is
not configurable. Error
detected during memory
configuration. See Troubleshooting
Memory on page 76.
E2012 Memory configured
but unusable. Check
DIMMs. Memory configured, but
is unusable. See Troubleshooting
Memory on page 76.
E2013 BIOS unable to shadow
memory. Check
DIMMs. The system BIOS failed
to copy its flash image
into memory. See TTroubleshooting
Memory on page 76.
E2014 CMOS RAM failure.
Power cycle AC. CMOS failure. CMOS
RAM not functioning
properly. Remove AC power to
the appliance for 10
seconds and restart the
appliance.
If the problem persists,
see
Getting Technical
Support on page 2.
E2015 DMA Controller
failure. Power cycle
AC. DMA controller failure. Remove AC power to
the appliance for 10
seconds and restart the
appliance.
If the problem persists,
see
Getting Technical
Support on page 2.
E2016 Interrupt Controller
failure. Power cycle
AC. Interrupt controller
failure. Remove AC power to
the appliance for 10
seconds and restart the
appliance.
If the problem persists,
see
Getting Technical
Support on page 2.
E2017 Timer refresh failure.
Power cycle AC. Timer refresh failure. Remove AC power to
the appliance for 10
seconds and restart the
appliance.
If the problem persists,
see
Getting Technical
Support on page 2.
Table 4 LCD Status Messages (Continued)
Code Text Cause Corrective Actions