Mirapoint RazorSafe 700, Hardware Manual

Page: 41 / 98

Integrated Remote Access Controller 6 (iRAC6) Enterprise
35
Installing an iRAC6 Enterprise Card
c
Only trained service technicians are authorized to remove the appliance cover and
access any of the components inside the appliance. Before you begin this procedure,
review the safety instructions that came with the appliance.
To install an iRAC6 Enterprise Card:
1. Power off the appliance, including any attached peripherals, and disconnect the
appliance from the electrical outlet.
2.
Open the appliance. See Opening the Appliance on page 30.
3.
Remove the plastic filler plug for the iRAC6 Enterprise port from the appliance
back panel. See
Back Panel Features and Indicators on page 10 for the port
location.
4.
If installed, remove all expansion cards from expansion-card riser 1. See
Removing an Expansion Card on page 49.
5. Install the iRAC6 Enterprise card:
a. Angle the card so that the RJ-45 connector fits through the back-panel
opening (
Figure 13 on page 36).
b.
Align the front edge of the card with the two front plastic retention
standoffs next to the iRAC6 connector on the system-board (
Figure 34 on
page 85) for the location of the connector.
c.
Press the card down until it is fully seated ( Figure 13 on page 36).
When the front of the card is fully seated, the plastic standoffs snap over the
edge of the card.
6. Reinstall all expansion cards in expansion-card riser 1. See Installing an
Expansion Card on page 48.
7.
Close the appliance. See Closing the Appliance on page 30.
8. Reconnect the appliance and peripherals to their power sources, and power
them on.