Mirapoint RazorSafe 700, Hardware Manual

Page: 39 / 98

Power Supplies
33
Figure 11 Installing a Hot-Swap Hard Drive
3.
Install the hot-swap hard drive.
a.
Press the button on the front of the drive carrier and open the handle
(
Figure 11 ).
b. Insert the hard-drive carrier into the drive bay until the carrier contacts the
backplane.
c.
Close the handle to lock the drive in place.
4. If applicable, install the bezel. See Installing the Front Bezel on page 29.
Power Supplies
Your appliance supports 870-W High Output power supply modules. The power
supply labels specify the maximum power output.
Removing a Power Supply
c
If troubleshooting a power supply mismatch error, replace only the power supply
with the flashing indicator. Swapping the opposite power supply to make a matched
pair can result in an error condition and unexpected appliance shutdown. To
change from a High Output configuration to an Energy Smart configuration or vice
versa, you must power down the appliance.
To remove a power supply:
1. On the failed power supply, disconnect the power cable from the power source
and the power supply, and remove the cables from the Velcro strap.
2.
Press the lever release latch and slide the failed power supply out of the chassis
(
Figure 12 ).
1 release button 2 hard drive carrier handle
2
1