Mirapoint RazorSafe 700, Hardware Manual

Page: 56 / 98

Replacing Appliance Components
50
2
Figure 23 Removing or Installing an Expansion Card
Removing Expansion-Card Riser 1
c
Only trained service technicians are authorized to remove the appliance cover and
access any of the components inside the appliance. Before you begin this procedure,
review the safety instructions that came with the appliance.
c
You must remove all expansion cards from the expansion-card riser before
removing the riser from the appliance.
c
The appliance does not start with a riser board removed.
To remove expansion-card riser 1:
1.
Power off the appliance, including any attached peripherals, and disconnect the
appliance from the electrical outlet.
2. Open the appliance. See Opening the Appliance on page 30.
3. Disconnect all cables connected to the expansion card.
4.
Remove all expansion cards from the expansion-card riser. See Removing an
Expansion Card on page 49.
5. Press the tab at the bottom of the riser to release the board from the card slot
and lift expansion-card riser 1 off of the mounting pins and out of the appliance
(
Figure 24 on page 51).
1 front card guide 2 expansion-card riser 2
3 expansion-card connector 4 expansion-card guide latch
5 expansion card
1
5
3
4
2