Mirapoint RazorSafe 700, Hardware Manual

Page: 51 / 98

RAID Battery
45
RAID Battery
Use the following procedures to replace a failed RAID controller card battery.
Removing a RAID Battery
To remove a RAID battery:
1. Pull back gently on the right edge of the battery bay and draw out the RAID
battery from the battery carrier.
2.
Disconnect the cable between the RAID battery and the storage controller card
(
Figure 21 ).
Installing a RAID Battery
To install a RAID battery:
1.
Connect the battery cable to the connector on the battery.
2. Locate the battery bay on top of the hard drive bays ( Figure 7 on page 28).
3. With the cable oriented toward the back, angle the left side of the RAID battery
into the left side of the battery bay (
Figure 21 on page 45).
4.
Rotate the right side of the battery down and press into the locked position.
5. If not already done, route the battery cable through the right chassis wall. See
Cable Routing .
6.
Connect the battery cable to the battery connector on the storage controller
(
Figure 19 on page 43).
Figure 21 Removing or Installing a RAID Battery
1 RAID battery 2 RAID battery cable from
storage controller
3 battery bay
3
2
1