Mirapoint RazorSafe 700, Hardware Manual

Page: 80 / 98

Troubleshooting Your Appliance
74
A
3.
Reconnect the appliance to the electrical outlet and power on the appliance.
4.
Enter the System Setup program.
If the date and time are not correct in the System Setup program, replace the
battery. See
System Battery on page 60.
If the problem is not resolved by replacing the battery, see Getting Technical
Support on page 2.
Troubleshooting Power Supplies
c
At least one power supply must be installed for the appliance to operate. Operating
the appliance with only one power supply installed for extended periods of time
without a power-supply blank installed in the PS2 power-supply bay can cause the
appliance to overheat.
To troubleshoot power supplies:
1.
Identify the faulty power supply by the power supply's status indicator. See
Power Indicator Codes on page 11.
c
If troubleshooting a power supply mismatch error, replace only the power
supply with the flashing indicator. Swapping the opposite power supply to
make a matched pair can result in an error condition and unexpected appliance
shutdown. To change from a High Output configuration to an Energy Smart
configuration or vice versa, you must power off the appliance.
2.
Reseat the power supply by removing and reinstalling it. See Installing a Power
Supply on page 34 and Installing a Power Supply on page 34.
b
After installing a power supply, allow several seconds for the appliance to
recognize the power supply and to determine if it is working properly. The
status indicator turns green to signify that the power supply is functioning
properly.
3. If the problem persists, replace the faulty power supply with the same type of
power supply.
If the problem persists, see Getting Technical Support on page 2.