Mirapoint RazorSafe 700, Hardware Manual

Page: 66 / 98

Replacing Appliance Components
60
2
3.
Align the processor with the socket keys on the ZIF socket ( Figure 29 ).
4.
Install the processor in the socket.
c
Positioning the processor incorrectly can permanently damage the appliance
board or the processor. Be careful not to bend the pins in the socket.
a.
With the release lever on the processor socket in the open position, align the
processor with the socket keys and set the processor lightly in the socket.
c
Do not use force to seat the processor. When the processor is positioned
correctly, it engages easily into the socket.
b.
Close the processor shield.
c. Rotate the socket release lever down until it snaps into place.
5. Install the heat sink.
a.
Using a clean lint-free cloth, remove the thermal grease from the heat sink.
c
Applying too much thermal grease can result in excess grease coming in
contact with and contaminating the processor socket.
b. Open the grease packet included with your processor kit and apply a spot
of thermal grease equal to the size of a finger nail to the top center of the
new processor.
c. Place the heat sink on the processor ( Figure 28 on page 58).
d. Close the heat-sink release levers ( Figure 28 on page 58).
6.
Install the cooling shroud. See Installing the Cooling Shroud on page 37.
7.
Close the appliance. See Closing the Appliance on page 30.
8. Reconnect your appliance and peripherals to their electrical outlets, and power
on the appliance.
System Battery
Removing the System Battery
c
Only trained service technicians are authorized to remove the appliance cover and
access any of the components inside the appliance. Before you begin this procedure,
review the safety instructions that came with the appliance.
w
There is a danger of a new battery exploding if it is incorrectly installed. Replace the
battery only with the same or equivalent type recommended by the manufacturer.
See your safety information for additional info.