Processors
59
Figure 29 Installing and Removing a Processor
c
Be careful not to bend any of the pins on the ZIF socket when removing the
processor. Bending the pins can permanently damage the appliance board.
11.
Lift the processor out of the socket and leave the release lever up so that the
socket is ready for the new processor.
If you are permanently removing the processor, you must install a processor
blank and a heat-sink blank in the CPU2 socket to ensure proper appliance
cooling. Adding the blanks is similar to installing a processor. See
Installing a Processor
c
Only trained service technicians are authorized to remove the appliance cover and
access any of the components inside the appliance. Before you begin this procedure,
review the safety instructions that came with the appliance.
n
In a single-processor configuration, the CPU1 socket must be used.
To install a processor:
1.
If you are adding a second processor for the first time, remove the heat-sink
blank and the processor blank from the vacant processor socket. Removing the
blanks is similar to removing a processor. See
2.
Unpack the new processor.
1
socket-release lever
2
processor
3
processor shield
4
notch in processor (2)
5
socket key (2)
6
ZIF socket
6
1
2
4
3
5
Summary of Contents for RazorSafe 700
Page 10: ...4 Preface ...
Page 32: ...About Your Appliance 26 1 ...
Page 96: ...Jumpers and Connectors 90 B ...
