Mirapoint RazorSafe 700, Hardware Manual

Page: 48 / 98

Replacing Appliance Components
42
2
Figure 18 Routing the Optical Drive Cable (3.5-inch Hard-Drive Chassis)
Integrated Storage Controller Card
Your appliance includes a dedicated expansion-card slot on riser 1 for an integrated
storage controller card that provides the storage subsystem for your appliance’s
internal hard drives. The controller supports SAS and SATA hard drives and also
enables you to set up the hard drives in RAID configurations as supported by the
version of the storage controller included with your appliance.
Removing the Integrated Storage Controller Card
c
Only trained service technicians are authorized to remove the appliance cover and
access any of the components inside the appliance. Before you begin this procedure,
review the safety instructions that came with the appliance.
To remove the integrated storage controller card:
1.
Power off the appliance, including any attached peripherals, and disconnect the
appliance from the electrical outlet.
2. Open the appliance. See Opening the Appliance on page 30.
3. Remove all expansion cards from expansion-card riser 1. See Removing an
Expansion Card on page 49.
4.
Disconnect the SAS cable(s) from the storage controller card.
1 optical drive connector 2 DVD/TBU_PWR connector
3 cable retention bracket 4 SATA_A connector
1 3
4
2