Mirapoint RazorSafe 700, Hardware Manual

Page: 49 / 98

Integrated Storage Controller Card
43
c
Disconnecting the RAID battery cable from a RAID card can cause data loss if
the dirty cache LED on the card is lit. The LED indicates that data is still cached
in controller memory and the data was not cleared at appliance shutdown.
5. If necessary, disconnect the RAID battery cable from the controller.
6.
Bend both card-edge guides outward and pull the storage controller card out of
the connector (
Figure 19 on page 43).
7. Bend outward on both card-edge guides to release the controller, lift the side of
the controller that is adjacent to the blue guide, and then remove the controller
out towards the rear of the chassis (
Figure 19 on page 43).
Installing the Integrated Storage Controller Card
To install the integrated storage controller card:
1.
With the storage controller card-edge facing the riser, insert one side of the card
into the black card-edge guide.
2. Bend outward on the blue card-edge guide, lower the card onto the blue card-
edge guide, and release the guide (
Figure 19 on page 43).
Figure 19 Installing a Storage Controller Card
3. Slide the storage controller’s card edge connector into the card slot on the riser
until the card is fully seated (
Figure 19 ).
1 dedicated storage controller card connector 2 riser 1
3 integrated storage controller card 4 RAID battery connector
5 SAS_1 connector 6 connector locking tabs
7 SAS_0 connector 8 card edge guides (2)
8
3
6
2
7
1
5
4