Mirapoint RazorSafe 700, Hardware Manual

Page: 62 / 98

Replacing Appliance Components
56
2
c
Handle each memory module only by the card edges, ensuring not to touch the
components on the module.
6. Reinstall the cooling shroud.
7. Close the appliance. See Closing the Appliance on page 30.
8.
Reconnect your appliance and peripherals to their electrical outlets, and power
on the appliance.
Installing Memory Modules
c
Only trained service technicians are authorized to remove the appliance cover and
access any of the components inside the appliance. Before you begin this procedure,
review the safety instructions that came with the appliance.
w
The memory modules are hot to the touch for some time after the appliance has
been powered down. Allow time for the memory modules to cool before handling
them. Handle the memory modules by the card edges and avoid touching the
components on the memory module.
To install memory modules:
1.
Power off the appliance, including any attached peripherals, and disconnect the
appliance from the electrical outlet.
2. Open the appliance. See Opening the Appliance on page 30.
3. Remove the cooling shroud. See Removing the Cooling Shroud on page 36.
4.
Locate the memory module sockets ( Figure 34 on page 93).
5. Press outward on the memory module ejectors to allow the memory module to
be inserted into the socket (
Figure 27 on page 55).
c
Handle each memory module only by the card edges, ensuring not to touch the
components on the module.
6. Align the memory module's edge connector with the alignment key of the
memory module socket, and insert the memory module in the socket.
c
The memory module socket has an alignment key that allows you to install the
memory module in the socket in only one way.
7.
Press down on the memory module with your thumbs until the ejectors lock
into position (
Figure 27 on page 55).
When the memory module is properly seated in the socket, the ejectors on the
memory module socket align with the ejectors on the other sockets that have
memory modules installed.
8. Repeat Steps 5 through 7 of this procedure to install the remaining memory
modules ( Table 5 on page 47).