Mindray DC-68, Service Manual

Page: 203 / 281

System Diagnosis and Support 11-13
11.3.7 Other Errors
11.4 Self Test
11.4.1 Self Test Introduction
The self test function, adopted by DC-70 series products, is used to test the connection of hardware
board and running status of the device. According to the access authority and tests, there are three
types of tests: production self test, maintenance self test and user self test. This chapter describes
the maintenance self test and user self test in detail.
11.4.2 Operation Procedure of Maintenance Self Test
NOTE: All tasks running on Doppler should be completed before entering system self test,
otherwise the self test system fails to respond. It is recommended to start self test
software to perform the self test after the system is generated.
1. Switch account
, type service password and service account to log in.
2. Select [Setup]-[Maintenance]-[Setup].
Click [Self Test] out of dialog box.
NOTE: if the current Doppler system is in Chinese, the self test performs Chinese system self test.
NOTE: if the current Doppler system is not in Chinese, the self test performs English system self
test.
Alarming tips LOG record Suggestion
Fail to open the file
"SystemConfiguration.ini", and
please check HDD data!
N/A Re-install the system software.
ADT7462 initialization error
XXX ADT7462
initialization error
；
Of which the names
of XXX ADT 7462
are as follows:
PC Board A
PC Board B
DC-DC Board
Re-install the system
software/check the drive/check the
digital board/check the front-end
power main board.