Page 7-5
|
Section 7.2: Replacing Components
7. If needed, apply a few drops of
lubrication to the chain through the
lubrication hole.
8. On the outboard puller assembly, if
applicable, locate the gap at the rear
bottom of the guard.
9. If needed, apply a few drops of
lubrication to the chain through the
gap.
10. On the inboard puller assembly, if
applicable, locate the gap in the guard.
11. If needed, apply a few drops of
lubrication to the chain through the
gap.
Section 7.2: Replacing Components
Warning!
Only a qualified technician may perform any maintenance on
machine. This may be a Miller Weldmaster representative or someone
trained by a Miller Weldmaster representative.
Warning!
Machine must be disconnected from power source before any
maintenance may begin.
Summary of Contents for T-100
Page 1: ......
