Page 2-4
Chapter 2: Heating System Overview and Adjustments
|
Section 2.1: Hot Air Heating System
Nozzle Height
The Nozzle Height is the vertical relationship that the Nozzle Tip has with the Weld
Rollers. The ideal height of the Nozzle Tip will be vertically centered between the Weld
Rollers so that the Air flow is directed into the pinch point. If the Nozzle is to high or to
low, welding speeds will not be as efficient as possible and may cause the fabric to be
ascetically overheated. Depress the Drive Foot Switch to swing the Nozzle into place and
check the height of the Nozzle Tip. If not properly placed,
(Figure2.7)
release the Drive
Foot Switch to swing Nozzle out and proceed with the following:
1.The Front Locking Bolt must be loosened
before adjustments can be made.Use a 3/
16” Allen Wrench to loosen the Front
Locking Bolt. The bolt should be just loose
enough to allow for the height of the
Nozzle to be adjusted.
(Figure2.8)
(Figure2.9)
2.Adjust the height of the Nozzle so that it is
vertically aligned with the Weld Roller
Pinch Point by turning the Height
Adjustment Knob.
(Figure2.9)
a. clockwise to adjust the Nozzle up.
b.counterclockwise to adjust the
Nozzle down.
3.Depress the Drive Foot Switch to swing
Nozzle into place and check to see if the
proper height adjustment of the Nozzle
has been made.
(Figure2.10)
Repeat steps
1 through 3 until correct.
4.Tighten the Front Locking Bolt.
5.Re-check the nozzle alignment once the
bolt is tightened, as slight movement may
occur.
Figure 2.7:
Figure 2.8:
Figure 2.9:
Figure 2.10:
Summary of Contents for T-100
Page 1: ......