Page 2-11
Chapter 2: Heating System Overview and Adjustments
|
Section 2.2: Wedge Adjustment
Wedge Left/Right Alignment
The left/right alignment is the horizontal relationship the Wedge has with the Weld
Rollers. The center of the Wedge Tip must be placed directly in the center of the Weld
Rollers. The edge of the tips must be placed so that neither side is left exposed on the
right or left side of the weld rollers. Having the Wedge Tip shifted to one side or the other
will result in the weld being shifted to the side that the Wedge Tip is favoring leaving the
opposite side unwelded. Check the left/right alignment.
(Figure2.30)
If not properly
placed proceed with the following:
1.The left/right adjustment bolts on the
Wedge assembly must be loosened before
adjustments can be made. Use a 3/16
Allen Wrench to loosen the 2 adjustment
bolts approximately one turn, the bolts
should be just loose enough to allow the
Wedge to be adjusted.
(Figure2.31)
2.Center Wedge on Weld Rollers by sliding
Wedge Mounting Bracket.
(Figure2.32)
3.Check to see if the proper alignment
adjustment has been made.
(Figure2.33)
Repeat steps 1 to 3 until correct.
4. When centered tighten Adjustment
Bolts.
Figure 2.30:
Figure 2.31:
Figure 2.32:
Figure 2.33:
Summary of Contents for T-100
Page 1: ......
