Page 2-9
Chapter 2: Heating System Overview and Adjustments
|
Section 2.2: Wedge Adjustment
Wedge Squareness
The Wedge squareness is the horizontal angle that the Wedge Tip has with the Weld
Rollers. This relationship should be parallel so that the Wedge Tip is aligned with the Weld
Rollers. Having the angle of the Wedge misaligned will cause the seam to be less than 100%
welded across the seam width. Check the squareness of the Wedge Tip and if not properly
placed
(Figure2.23)
proceed with the following:
1. Loosen the two green clamping collars
(not the top stainless steel) just enough
to allow from rotation of the Wedge
Shaft
(Figure2.24)
2.Rotate the Mounting Shaft until the
Wedge Tip is parallel with the Weld
Rollers
(Figure2.25)
3.Tighten the green Clamping Collars
a. As the green clamping collars are
tightened, the wedge squareness
may move slightly out of alignment.
Allow for this when tightening.
4.Check to see if the proper angle
adjustment of the Wedge has been made.
(Figure2.26)
Repeat steps 1 through 4
until correct.
Figure 2.23:
Figure 2.24:
Figure 2.25:
Figure 2.26:
Summary of Contents for T-100
Page 1: ......
