Page 55
Operation and Maintenance
combiSENSOR 64x0
A change from the EtherCAT interface back to the Ethernet interface is possible with the hardware switch on
the KSS64x0 basic unit or via the corresponding CoE Object. In both cases, then a restart of the controller is
required.
To integrate the EtherCAT interface e.g. within TwinCAT an ESI-file is supplied.
You will find further instructions in the appendix, see Chap.
A 2
.
8.
Operation and Maintenance
Please take care of the following:
Make sure that the sensor surface is always clean.
Switch off the power supply before cleaning.
Clean with a damp cloth; then rub the sensor surface dry.
Changing the target or very long operating times can lead to slight reductions in the operating quality (long
term errors). These can be eliminated by recalibration.
Disconnect the power supply before touching the sensor surface.
> Static discharge
> Danger of injury
In the event of a defect in the controller, the
sensor or the sensor cable, the parts concerned
must be sent back for repair or replacement. In
the case of faults the cause of which is not clearly
identifiable, the whole measuring system must be
sent back for repair or replacement to:
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Königbacher Straße 15
94496 Ortenburg / Germany
Tel. +49 (0) 8542 / 168-0
Fax +49 (0) 8542 / 168-90
[email protected]
www.micro-epsilon.com
