Page 26
Operation
combiSENSOR 64x0
5.
Operation
5.1
Starting Up
Connect the display/output devices through the signal output socket, see Chap.
4.6
, before connecting
the device to the power supply and switching on the power supply.
i
Allow the measuring system to warm up before the first measurement or calibration for approximately
15 min.
Fig. 12 Change Ethernet/EtherCAT, basic module KSS6420
A switch between Ethernet and EtherCAT, is possible via a hardware switch, see
Fig. 12
or via software on the
basic unit KSS64x0, see Chap.
7.2
.
If the switch is in position
EN
(Ethernet
)
, always the Ethernet interface is active independent of the software
setting. If the switch is in position
EN/EC
(Ethernet/EtherCAT), then the active interface depends on the
software setting. To change the interface it is necessary to restart the controller.
